Matek H743-Slim H7 30x30 Flight Controller V3
The Matek H743-Slim V3 is a powerful flight controller using the HSTM32H743VIT6 MCU running at 480MHz. It is matched with dual gyros ( ICM42688P & ICM42605), an Infineon DPS310 barometer, and up to 13 PWM outputs. Measuring 36x36x5mm, this is a full-featured and very worthy choice for anyone looking for a flight controller that can work on quads or wings.
Specifications:
- MCU: STM32H743VIH6, 480MHz , 1MB RAM, 2MB Flash
- IMU: ICM42688P (SPI1) & ICM42605 (SPI4)
- Baro: Infineon DPS310 (I2C2)
- OSD: AT7456E (SPI2)
- Blackbox: MicroSD card socket (SDIO)
- 7x Uarts (1,2,3,4,6,7,8) with built-in inversion.
- 13x PWM outputs (including “LED” pad)
- 2x I2C
- 1x CAN
- 6x ADC (VBAT, Current, RSSI, Analog AirSpeed, Vbat2, Cur2)
- 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
- 1x SPI3 breakout
- USB Type-C(USB2.0)
- 1x JST-SH1.0_8pin connector (Vbat/G/Curr/Rx8/S1/S2/S3/S4)
- 1x JST-GH1.25_4pin connector (5V/CAN-H/CAN-L/G)
- Dual Camera Inputs switch
- 5V/Vbat filtered power ON/OFF switch
- DJI FPV OSD is supported by any spare UART
- Mounting:
- 30.5 x 30.5/Φ4mm
- 30x5 x 30.5/Φ3mm with Grommets
- Dimensions: 36x36x5mm
- Weight: 7g
Power:
- Vbat Input: 6~36V (2~8S LiPo)
- BEC: 5V 2A cont. (Max.3A)
- LDO 3.3V: Max.200mA
- No Current Sensor built-in
- ADC Vbat2 pad supports Max. 69V (voltage divider: 1K:20K)
- Static power: 200mA@5V with Betaflight, 150mA@5V with ArduPilot
Firmware:
- ArduPilot(ChiBiOS): MATEKH743
- BetaFlight: MATEKH743
- INAV: MATEKH743
Includes:
1x Matek H743-Slim H7 30x30 Flight Controller V3
6x Silicon Grommets M4 to M3
1x JST-SH1.0_8pin cable, 5cm
2x JST-SH1.0_8pin Connectors
1x JST-GH-4P to JST-GH-4P Cable for CAN Port, 20cm
