ZeeZ Design F7 2020 and 45A BLHeli_32 Stack

ZeeZ Design F7 2020 Flight Controller and 45A 4-in-1 BLHeli_32 ESC stack has all the features of its big sister but in small form factor.  Features 20x20 mounting holes, small size, and direct soldering connection and board space for TBS Nano RX and TBS Unify Pro32 Nano, this is a builder's dream.  

F7 2020 Flight Controller Specifications:

• Mounting Holes 20×20
• Direct solder connection and board space for TBS Nano RX and TBS Unify Pro32 Nano providing the ultimate in clean stack installation.
• Up to 8S input (max 36V)
• 5V BEC up to 3A continuous
• STM32F722 MCU (Support Betaflight, INav, Emuflight)
• MPU6000 Gyro/ACC for smooth performance
• 128MB Onboard flash
• OSD chip Onboard
• 6 available UARTS
• VTX switch to control the ON/OFF of the VTX
  directly from your transmitter (control via Betaflight with USER1 mode)
• LC Filter for 5V VTX and Camera
• USB Type C connector
• Onboard RGB LED distribution for clean wiring
  to the LED on the arm of the quad.
• 8 Onboard RBG LED (compliant with FAI Rules)
• Logic Side and USB current protection

45A 4-In-1 BLHeli_32 ESC Specifications:

• Mounting Holes 20×20
• 3S to 6S input
• Constant Current: 45A
• Peak Current: 55A
• STM32L4 MCU (ARM Cortex M4, 80MHz frequency)
• BlHeli32 Firmware (support Dshot150/ Dhsot300 /Dshot600/ProShot 1000) and still compatible with all older analog protocol (OneShot42, OneShot125, Multishot)
• 8 Pin JST connector and 8 Pin solder pads
• Holes for Aluminum Low ESR capacitor (included 35V 470uF Low ESR capacitor and a spare capacitor)
• Onboard analog current sensor (Betaflight Scale: 200)
• ESC telemetry to read RPM and ESC temperature
• Compatible with Bidirectional Dshot out of the box

Weight and Dimension:

• Weight (including FC+ESC+ 8X Standoff + 4X Nut + 8 Pin connector) : 19.9gr
• Dimensions: ( L X W X H) : 41.6mm X 33.6mm X 19.6 mm

Includes:
1x Zeez F7  2020 Flight Controller
1x Zeez ESC 4in1 45A 2020
8x Aluminum Standoff
4x Aluminum Nut
1x ESC to Flight Controller 8 Pin to 8 Pin 
1x ESC to Flight Controller 8 Pin to Free wires (with JST SH crimp) 
1x ESC to Flight Controller 8 Pin to Servo Connector
1x JST SH 8 Pin Plastic Housing
1x JST SH 10 Pin Plastic Housing
2x 470uF 35V Low ESR Capacitor
1x XT60 with 12AWG Silicon Cable for battery connection
2x 2.00mm Header Pin for VTX connection
2x 2.54mm Header Pin for Receiver connection
4x Spare M3 rubber anti-vibration for Flight Controller or ESC