TBS Lucid AIO 1-2S Flight Controller
** Pre-Order - Arriving Early December **
The TBS Lucid AIO 1-2S was engineered to tick many boxes for long-range 1S/2S drone pilots and whoop pilots who don't enjoy radio link limitations and need a bit of extra power from their stack.
Built to a 25x25 "Whoop" form factor, it is the only board with the necessary grunt to run 2S boards without burning out, while also capable of running 1S batteries down so low you will hear them beg for mercy.
The "AIO" stands for all-in-one, or a 3-in-1, specifically. It includes a Flight controller, 4in1 ESC, and Crossfire Receiver. It also comes with an OSD chip for analog video.
Each TBS Lucid AIO is tested out of the factory and has been put through the wringer by some of the most seasoned whoop pilots before being offered for sale, which further distinguishes the board from some of the incumbents.
Specifications:
- MCU: AT32F435RMT7, 288MHz
- Gyro: ICM-42688P
- ESC: 4 x 7A (24A total max) with telemetry and current sensor
- BEC: 5V 2A
- OSD: AT7456E
- Blackbox: 8M
- UARTs: 3 (UART1/UART3/UART5)
- Input: 1S-2S
- Dimensions: 28mm x 28mm (30mm x 30mm outer dimensions)
- Mounting: 25mm x 25mm
- Weight: 4g
Default/Recommended Port Assignments:
- UART1: Spare
- UART2: Smart Audio
- UART3: DJI O3 Air Unit
- UART5: CRSF Rx (Included on board)
Includes:
1x TBS Lucid AIO 1-2S Flight Controller
1x TBS Crossfire "Micro RX" Antenna
4x Rubber Grommets
4x Motor Sockets Unsoldered (for plug & play)
